Toothpick F722 2-6S AIO Brushless FC 35A (BLHeli_S) ICM42688 By BetaFPV

Bullet Points

• Better performance capability and higher calculation speed for more stable and smoother flight.
• Has specially added 6-pin connector for DJI Digital VTX.
• 6 full UARTs for more options for external parts like VTX, GPS, Receiver and other components.
• More stable voltage and current
• Can handle 35A continuous current(40A burst), totally supports the 2-6S lipo battery for a stronger flight performance.

Recommended Parts (not included)

• BNF: highly recommend for TWIG ET5 and X-Knight 5'' Toothpick Quad
• Battery: 550mAh 6S 75C battery, 450mAh 4S battery, 4S 1000mAh Battery
• VTX: M02 25-350mW 5.8G VTX, A02 25-800mW 5.8G VTX
• Motor: 1805 1550KV brushless motor, 2004 Brushless Motors, 1606 Brushless Motor, 1506 Brushless Motor
• Compatible Propellers: Gemfan 5125 3-Blade props and Gemfan 5020 props
• Frame: 4-5 inch Frame, highly recommend for TWIG ET5 5'' Toothpick Frame, X-Knight Carbon Fiber 5'' V2 Frame Kit and X-knight 5'' frame

FC Specifications

• Item: F722 35A AIO FC(BLHeli_S)
• Weight: 7.06g
• CPU: STM32F722RET6
• Six-Axis: BMI270 (SPI connection)
• Mounting hole size: 26mm * 26mm
• Firmware version: betaflight_4.2.x_BETAFPVF722
• OSD: Built-in BetaFlight OSD (OSD chip: AT7456E)
• Support programmable LED like WS2812 etc
• Built-in current sensor

ESC Specifications

• Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
• Receiver: Support Frsky XM/XM+ Receiver/ Futaba Receiver/Flysky Receiver/DSMX Receiver/TBS Crossfire Receiver (requires external connection)
• Input voltage: 2S-6S Lipo
• Continuous current: 35A
• Peak current: 40A
• ESC firmware: BLHELI_S
• Indicators: 2 indicators: receiver indicator (green)/Flight control power indicator (red)
• Capacitance: CS|5*10*13mm|470μF|35V
• Connecter: 80mm 14AWG silicone cable with XT60
• Recommended motors: 14XX series, 15XX series, 16XX series, 18XX series, 20XX series

Included

• 1x Toothpick F722 35A AIO 2-6S brushless flight controller
• 1x Cable Pigtail (XT60U)
• 1x Capacitor
• 1x 6-Pin Connector for DJI Digital VTX
• 4x M2x10mm Screws
• 8x M2 Nuts