This RushFPV Extreme Edition 60A 4in1 ESC is equipped with an aluminum shell, a 200MHz F4 MCU with BLHeli_32 Firmware and a 24Hz-128KHz PWM frequency dual board.
Bullet points
BLHeli_32 firmware is the third generation of BLHeli firmware, following base BLHeli and BLHeli_S.
32-bit microprocessor running at a frequency of up to 200MHz for an excellent performance.
Supports up to 128K PWM frequency, so the response speed is faster and smoother, reducing mid-throttle oscillations.
Equipped with double-sided lightweight metal armor to avoid hardware damage caused by crashes, and the armor can effectively assist the MOSFET to dissipate heat.
Double PCB board design, high current circuit, and signal circuit are independent of each other.
All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also causing active freewheeling.
Supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power-up, No need for throttle calibration.
Supports beacon functionality, where the ESC will start beeping after a given time of zero throttles. This can be very useful for finding a lost drone.